Electrical Checks for Assembled Boards
Topline Circuit uses movable probes to check selected connections and component values on assembled boards. Flying probe testing is an option for prototypes, short runs and assemblies with frequent design revisions. Moving probes can perform the agreed checks without a dedicated bed-of-nails fixture.
Send your assembly revision, build quantity and priority checks. We review contact access, test coverage and programming requirements with your PCB assembly quote.
What Flying Probe Testing Can Check
| Check | What we review | What to specify |
|---|---|---|
| Continuity | Check for opens along selected connections between accessible nodes. | Net names, accessible endpoints and the maximum acceptable resistance for each continuity check. |
| Shorts | Check selected pairs of nets for unintended connections, accounting for legitimate paths through fitted components. | Critical net pairs, expected paths through fitted components and the applicable resistance or current limit under the agreed test conditions. |
| Component values | Measure selected component values where probe access and the surrounding circuit allow a meaningful reading. | Reference designators, nominal values, allowable ranges and any specified measurement conditions. |
Review Probe Access After Assembly
Probes may contact exposed test pads or suitable component terminals. We review pad dimensions, spacing, board side and clearance around tall parts, connectors and other obstructions. Send coordinates with their units and origin when available.
Identify any locations where contact is prohibited. We confirm the checks that can run on the assembled board and flag any inaccessible points before testing begins.
Match the Program to the Build
Use the same released revision across the CAD data, schematic, BOM and assembly drawing. Include fitted variants, do-not-populate positions and approved substitutions that could affect readings.
For repeat builds, confirm whether layout, access or component values changed. We review the impact on the program, limits and test cycle time before running the updated assembly.
Review Failures and Report Results
When a measurement fails, we review the result against the agreed limit and verify probe contact where applicable. We record the failed test, affected net or component reference and measured value. After authorized rework, we repeat the applicable checks and link the result to the original record.
Specify whether you need results by board serial number or lot. Agree on the fields and report format when requesting a quote.
Files for a Flying Probe Quote
- Released CAD data or a test-point map with net names, coordinates, units, origin and board sides
- Schematic, BOM, assembly drawing and assembly revision
- Build quantity, priority checks and any restrictions on probe contact
- Test limits and required unit or lot reports
Flying Probe Testing FAQs
Possibly. Send the layout, schematic and assembly drawing. Mark the nets you need checked and any surfaces that probes must avoid. We review exposed pads and terminals, then identify checks that need a different access point or a complementary test.
Send your build quantity, expected repeat orders and required checks. Flying probe can reduce the need for dedicated tooling. For repeat builds, ask us to compare program and fixture costs, time per board and coverage of your priority checks.
Flying probe verifies the electrical checks in the agreed program. To verify operating behavior, specify the supply settings, loads, inputs and expected outputs so we can plan a functional test.
Send the updated CAD data, schematic, BOM and assembly drawing, with changes marked. Include any changes to fitted variants, test points or acceptance limits so we can review program updates.
Request serial-number reporting when asking for a quote. Specify the serial number format and the fields you need, such as test program revision, net or component reference, measured value, acceptance limit and pass/fail result. Tell us the file format so we can confirm the reporting scope.
We review the failed step and measured value, check contact where applicable and record the finding. If you authorize rework, we repeat the agreed checks and link the retest result to the same board or lot.
Discuss Your Flying Probe Test Requirements
Send your assembly revision, layout, build quantity and priority nets or components. Include test limits and reporting requirements so we can review the scope for your quote.
