PCBA Electrical Testing

Electrical Testing for Assembled Boards

Topline Circuit provides electrical testing for assembled circuit boards. Tell us which connections, components and operating functions you need to verify. We review probe access, fixture needs and pass/fail limits with your PCB assembly quote.

Choose a Test Method for Your Assembly

Test methodWhat it checksWhat to provide
Assembly flying probeChecks for shorts and opens, plus selected component measurements at accessible points. Suitable for prototypes or short runs where access and coverage allow.Schematic, test-point map, BOM and priority checks.
In-circuit testing (ICT)Selected connections and component values using a fixture and board-specific program. Coverage depends on access and circuit topology.Test-point coordinates, board side, schematic, BOM, build quantity and fixture details.
Functional circuit testing (FCT)Specified behavior with the assembly powered and connected to the required loads and interfaces.Test sequence, firmware revision, supply settings, loads, expected outputs and pass/fail limits.

Review Test Access Before Fixture Design

Send the board layout or test-point map with coordinates, coordinate units, the origin, board side and access restrictions. Identify the priority nets and component measurements so we can check whether probes can reach them after assembly.

If access is limited, we can review connector-based checks or discuss which test points to add in the next revision.

Illustration of test probes contacting accessible test points on an assembled circuit board

Define Functional Test Conditions

Illustration of an assembled circuit board connected to a power supply, test interface and electronic load

Provide the supply voltage, current limit, loads, firmware version and steps for each test mode. For each step, list the expected response, the allowable range and the time allowed for the response. Include any startup sequence, reset or shutdown instructions.

Identify who provides the fixture, cables and any reference unit. Share programming and interface requirements before the first build.

Link Test Results to Boards or Lots

Specify whether to record results by serial number or lot. Agree on the file format and fields, such as assembly revision, test procedure revision, measured values and pass/fail status.

Define how failures are recorded and which checks must be repeated after authorized rework. Include any required release approvals in the test plan.

Illustration linking a circuit board serial number to measured test results and a pass or fail record

PCBA Electrical Testing FAQs

Yes, where the board provides suitable access. Send the schematic, test-point map, build quantity and priority checks. We review the available flying-probe coverage and any interface tests, then confirm the setup and fixtures required for the prototype run.

Send the layout, schematic and connector pinout. We review accessible nodes and connector signals, then identify which checks are possible and which need additional access.

ICT checks selected accessible connections and component values. Functional testing checks operating behavior under defined inputs and loads. Send the schematic, build quantity and required checks so we can review whether your project needs one or both methods.

Send the power requirements, firmware revision, connector pinout and functions you need to verify. Include known expected outputs and an approved reference unit if available. We review the missing steps, loads and pass/fail limits with your team before you approve the procedure.

Yes. Request unit-level reporting when you ask for a quote. Provide the serial number format and specify the required test steps, measured values, limits and report format. We confirm the reporting scope with the test plan.

We record the failed step, measured result and test procedure revision, then hold the affected unit for review. Agree on who can authorize rework and which checks to repeat. After approved rework, we record the retest result against the same unit or lot identifier.

Discuss Your PCBA Test Requirements

Send your assembly revision, schematic, test-point map and required checks. Include your build quantity, fixture details, firmware revision, pass/fail limits and reporting requirements so we can review the scope for your quote.