Fixture-Based Testing for PCB Assemblies
Topline Circuit offers in-circuit testing for assembled boards. A board-specific fixture brings spring-loaded probes into contact with selected nodes so the test program can check for assembly faults and measure selected component values.
Send your assembly revision, production quantity and priority checks. We review fixture requirements and achievable coverage with your PCB assembly quote.
What In-Circuit Testing Can Check
| Check | What ICT can verify | What to specify |
|---|---|---|
| Opens | Continuity between accessible nodes that should be connected. | Net names, endpoints and maximum acceptable resistance. |
| Shorts | Unintended connections between selected nets, accounting for expected paths through fitted components. | Priority net pairs, expected paths through fitted components, and the applicable resistance or current limit for the agreed test conditions. |
| Component measurements | Resistance or capacitance of selected components where the probes can reach the relevant nodes and surrounding circuitry permits a meaningful measurement. | Component reference designators, nominal values, acceptable ranges and any specified test voltage, current or frequency. |
Review Test Access Before Building a Fixture
Send a test-point map with net names, XY coordinates, units, origin and board side. Include pad dimensions, component heights, permitted board support areas and locations where fixture contact is prohibited. We review probe clearance and board support on the assembled board.
Identify mandatory checks so we can flag inaccessible nodes and discuss complementary tests before committing to a fixture.
Confirm Fixture and Program Compatibility
If you have a fixture, send its drawing, probe map, interface details, tester model and program revision. Identify the board revision the fixture was built for.
For a revised build, identify changes to board outline, mounting or locating holes, test points, component heights and approved substitutions. We review mechanical fit, electrical compatibility and program changes before reuse.
Agree on Results and Retest Records
Specify whether you need results by serial number or lot. Agree on the file format and fields, such as assembly revision, test program revision, net or component reference, measured value, acceptance limit and pass/fail result.
When a check fails, we record the result and review probe contact where applicable. After authorized rework, we repeat the agreed checks and link the retest to the original record.
Files for an ICT Quote
- Released CAD data, schematic, netlist, BOM and assembly drawings
- Test-point map, board outline and fixture contact restrictions
- Assembly revision, fitted variants, substitutions and build quantity
- Required checks, limits, existing fixture details and reporting scope
In-Circuit Testing FAQs
Send the old and new revisions, a marked list of changes, and the existing fixture and program details. We check whether the probes still align and the board fits the fixture. We also confirm which readings and limits need program updates before the revised assembly runs.
Mark the net on the schematic and layout. We check whether the fixture can reach an exposed terminal or pad on that net. If access is limited, we identify the affected checks so you can decide whether to add a test point or use a complementary test.
Share your current build size, expected repeat orders and required checks. Ask us to compare fixture and programming costs, test time per board and coverage of your priority checks for both methods.
Share the failed functional step, operating conditions, firmware revision and board serial number. We compare the failure with the ICT coverage and review which additional measurements can help isolate the cause.
Yes. Request a serial-number report when asking for a quote. Specify the serial number format, required measurements, limits, program revision, pass/fail results and whether retest records must be included.
We check probe condition and board seating, then repeat the affected check as allowed by the agreed test procedure. We keep the original reading and the retest result under the same board serial number or lot. If the failure persists, we hold the board for review.
Discuss Your ICT Requirements
Send your assembly revision, build quantity, priority checks and test-point data. Include details of any existing fixture, along with test limits and reporting requirements so we can review the scope for your quote.
